Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Setting node command authority z/OS JES2 Commands SA32-0990-00 |
|
The $T NODE(nnnn),AUTH= command sets the command authority to be attributed to all commands originating at a specific node. (To use this command, you need to have system authority.) Use any combination of the following authority codes:
In addition to network authority, system, job, or device authority is required to have commands take effect at another node. Note: In a MAS configuration, enter the $T NODE(nnnn),
AUTH= command on each member of the node because each member maintains
its own version of the node information table.
|
Copyright IBM Corporation 1990, 2014
|