Explanation
The configuration configname is
no longer preferred for HyperSwap® and
may not be used if and when a HyperSwap is
initiated.
In the message text:
- configname
- Name of the configuration.
- reason
- One of the following reasons:
- Not duplex
- One or more device pairs in the configuration is not in full duplex.
- CDS included
- An XCF couple data set resides on one of the devices in the configuration.
- Ineligible by JES3
- One or more devices in the configuration is allocated and determined
not eligible for HyperSwap by
JES3.
- Unknown reason
- Configuration is disabled for HyperSwap due
to an unknown reason.
System action
Operator response
Determine the reason that causes the configuration
not ready for HyperSwap and
make corrections so that the configuration becomes ready for HyperSwap again.
System programmer response
Source
z/OS® IOS Basic HyperSwap
Module
Routing code
Descriptor code