IOS103I

interval

Explanation
The system displays this message in response to
a D IOS,RECOVERY command and Indicates which RECOVERY functions are enabled.
Displays whether the PATH RECOVERY SCOPE is by CU or DEVICE. If
the PATH RECOVERY SCOPE is by CU, the interval and threshold parameters
are displayed.
Displays whether IOS enabled interrupt processing
will issue the IOS115A WTOR message via DCCF or load a non-restartable
WAIT 140 if a 'no paths' or 'intervention required' condition occurs
on a paging device.

For information about how to set
the RECOVERY options, see z/OS MVS System Commands.
In
the message text: hh.mm.ss
The time in hours, minutes and seconds.
ss
The limited recovery time in seconds.
PATH RECOVERY SCOPE IS BY {CU | DEVICE}
Indicates that path recovery is by either control unit or device.
interval
The path recovery interval in minutes and is only displayed if
PATH RECOVERY SCOPE IS BY CU.
threshold
The path recovery threshold in number of errors per minute and
is only displayed if PATH RECOVERY SCOPE IS BY CU.
DCCF IS SET TO {MESSAGE | WAIT_STATE}
Indicates that IOS enabled interrupt processing either uses DCCF
to issue the IOS115A WTOR message or loads a non-restartable WAIT
140.

System action
The system continues processing.

Operator response
None.

Source
Input/output supervisor (IOS)

Module
IOSCPARZ

Routing code
2,10

Descriptor code
4