EDG6424E

Explanation
During EDGBKUP forward recovery of the DFSMSrmm
control data set, DFSMSrmm found that the journal did not contain
the records that match     to     the control data set that is being
recovered.
This is the result of using the wrong DFSMSrmm control
data set, the wrong journal, or running EDGUTIL on the control data
set before forward recovery. If concatenated journal backups have
been input to EDGBKUP, this message applies to all the data sets in
the concatenation. DFSMSrmm was unable to find the journal records
to match the control data set. There might be no journal records that
are more recent than the restored control data set backup, or the
journal records created since the start of the control data set backup
are not present in the journal concatenation.
During
SMFIN forward recovery, journal records are created from SMF records.
This might have caused the JOURNAL DD entry specified in the message
to have been created.

System action
The EDGBKUP utility continues with the forward
recovery request and sets return code 4. If any journal records have
a more recent time stamp than the control data set, they are used
for forward recovery.

Operator response
None.

System programmer response
Ensure that the correct DFSMSrmm control
data set and journal have been used for this recovery request. To
see if any journal records have been processed, look for the EDG6410I,
EDG6411I, and EDG6412I messages in the SYSPRINT file. Use the information
in message EDG6431I to check the control data set and journal time
stamps. If the control data set time stamp is between the start and
end times from the journal, all possible records have been recovered
from the journal. 
You can ignore this error if you understand
why the situation occurred. For example, if you know that you might
have lost a particular backup of the DFSMSrmm control data set or
journal, you can ignore this error. To respond to the error, you should
select the correct backups and retry recovery. Run the EDGUTIL utility
with VERIFY(ALL). When this completes with return code zero, the DFSMSrmm
control data set error indicators are reset.
If the control
data set backup was created using the BACKUP(DSS) option, any restore
of the control data set must use the journal backup taken at the same
time as the control data set backup. If you do not use the journal
backup taken at the same time, you will have missing journal records.
To correct the error, add the name of the journal backup that should
be used.  For recovery from the latest control data set backup, use
the latest journal backup and the active journal.

Source
DFSMSrmm

Module
EDGBKUP