CBR1064I Command rejected. Volume serial number volser undefined.
Explanation
The operator entered a command that requires the specification of a volume serial number.
For commands affecting optical volumes, the volume serial number volser is either not defined in the optical configuration data base, or the optical configuration data base contains invalid fields in the row for the specified volume serial number. This message is preceded by a message or messages that contains information about the nature of the invalid fields in the optical configuration data base for the volume serial number.
For commands that affect tape volumes, either the volume serial number volser is not defined in the tape configuration database, or the volume serial number is defined in the tape configuration database but is for a volume that is not supported by the level of OAM software on this system (volume record contains uplevel tape device selection information). The possibility also exists that the volume serial number that is specified is defined in the tape configuration database. However, a save control data set was activated that does not contain any tape library definitions.
System action
The command is rejected.
Operator response
Determine the cause of the error, then enter a command with a valid volume serial number.
If the request failed because the volume is not supported on this OAM software level, reissue the command on a system where it is supported.
Source
Object Access Method (OAM)
Routing Code
2
Descriptor Code
5