CBR0300I {TAPEUNITNAME | L2TAPEUNITNAME} unit-name contains invalid device types.
Explanation
This message is issued for one of
the following conditions:
- OAM is processing the SETOAM commands in the CBROAMxx member of PARMLIB. The TAPEUNITNAME or L2TAPEUNITNAME keyword was specified on the SETOAM command with an esoteric unit name.
- An operator has entered an F OAM,UPDATE,SETOAM,scope,TAPEUNIT,unit-name or an F OAM,UPDATE,SETOAM,scope,L2TAPEUN,unit-name with an esoteric unit-name.
At least one tape drive contained in esoteric unit name unit-name has a device type other than the devices supported by OAM.
Device
types supported by OAM are as follows:
- 3480 - an IBM® base 3480 device
- 3480X - an IBM 3480 device with the IDRC feature, or an IBM base 3490 device
- 3490 - an IBM 3490E device (may be emulated by other IBM devices)
- 3590-1 - an IBM 3590 device (may be emulated by other IBM devices)
System action
- If this message was issued during OAM initialization, OAM continues processing all of the SETOAM commands in the CBROAMxx member of PARMLIB, but OAM initialization will terminate after all the SETOAM commands in the CBROAMxx member of PARMLIB have been processed.
- If this message was issued as a result of an operator command, the operator command stops.
System programmer response
Make sure that the esoteric unit name specified in the TAPEUNITNAME or L2TAPEUNITNAME keyword on the SETOAM command(or the TAPEUNIT or L2TAPEUN keyword on the UPDATE command) contains only tape drives whose device types are supported by OAM.
Source
Object Access Method (OAM)
Routing Code
2
Descriptor Code
4