Windows: Installing S-TAP agent using the interactive installer
The interactive installer is useful for smaller deployments or whenever a guided, step-by-step installation experience is required.
Before you begin
Verify the following before you begin:
- Review the Windows S-TAP installation requirements at Windows: Prerequisites: installing S-TAP.
- Verify that your database server and operating system are supported.
- Identify the IP address of the database server or domain controller where you will install the S-TAP, including any virtual IP addresses.
- Identify the IP address of the Guardium system that will control the S-TAP.
- Verify that the intended S-TAP installation directory is empty or does not exist.
- Obtain the S-TAP module from either Fix Central, or your Guardium representative.
About this task
When installing an S-TAP on a database server, you must provide the IP address or host name of the Guardium system that will receive data from the S-TAP. After the S-TAP has connected to the Guardium system, navigate to the page and complete the S-TAP configuration.
Note: Windows S-TAP parameters cannot be changed via the interactive installer during upgrading. The
user can use the GUI after the upgrade to change Windows S-TAP parameters.
Procedure
What to do next
Verify that the S-TAP is communicating with the Guardium system by navigating to and reviewing the S-TAPs status and configuration.