Product Documentation
Abstract
Instructions for removing ServeRAID 7K card card from an xSeries 346 server.
Content
Text from the audio portion of the ServRAID-7K card removal movie
To remove the ServRAID-7K card:
- Remove the cover by pressing in the cover release latch and rotate up while sliding the cover the rear approximately one-half inch.
- Lift the cover off and place to the side.
- Remove the low-profile riser card by pushing out on the release latch that secures the card.
- Grasp the ends of the card and pull the entire assembly out and place on an ESD protected surface.
- Remove the full-length riser card by raising the latch handle to the open position.
- Grasp the ends of the card and pull the entire assembly out and place on an ESD protected surface.
- Remove the ServRAID-7K card by flexing the retaining bracket to release the card and lift straight up to remove the card from the connector.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW20Q","label":"xSeries 346"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-58202