IJ39792: SPATIAL DOES NOT RESPECT LAYER VISIBILITY SAVED IN PLUSSTOOLPERSISTENCE TABLE

APAR status

• Closed as program error.

Error description

• STEPS TO REPRODUCE:
  1. Make sure the system property
  "mxe.pluss.toolspersistence.enable" is set to 1.
  2. Go to SR application.
  3. Open any SR.
  4. Move to the Map tab.
  5. Open the Layers tool.
  6. Unselect every checkbox, except for the basemap and any other
  
  layer.
  7. Leave the application.
  8. Open the SR application again.
  9. Open any SR.
  10. Move to the Map tab.
  11. Wait for the map to load.
  
  RESULT:
  The whole map loads with every layer, not respecting what's in
  the plusstoolpersistence table. If you re-open the Layers tool,
  its setup will be just like when you left the application, but
  the map does not correspond to what's set there.
  
  EXPECTED RESULT:
  The map to respect the layer visibility that's been saved in the
  
  plusstoolpersistence table.
  
  REPORTED IN VERSION:
  TPAE 7612 + Spatial 7610
  

Local fix

• N/A
  

Problem summary

• ****************************************************************
  * USERS AFFECTED:                                              *
  * All TPAE/Spatial users                                       *
  ****************************************************************
  * PROBLEM DESCRIPTION:                                         *
  * SPATIAL DOES NOT RESPECT LAYER VISIBILITY SAVED IN           *
  * PLUSSTOOLPERSISTENCE TABLE                                   *
  ****************************************************************
  

Problem conclusion

• The fix for this APAR was made directly on source code
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  MAXIMO ASST MGM

• Fixed component ID

  5724R46AM

Applicable component levels