Hardware Management Console Bios update for HMC models 7315-CO1

Follow these steps to update the current BIOS revision level on your HMC.

Create a diskette

1. Place a formatted diskette into your Windows PC diskette drive.
2. Execute the binary 20KT46A.exe from a Windows PC.
3. Select to write the BIOS to the diskette and create a bootable diskette.

Update the BIOS

The BIOS update procedure contains several steps.

1. Find and record the machine type and model (MTM) number of your HMC as follows:
   • Check the label on the front of the HMC.
   • Run the lshmc -v | grep TM command.
   The MTM should be 7315-C01 or 6792-LPU
2. Find and record the serial number of the HMC as follows:
   • Check the label on the front of the HMC.
   • Run command lshmc -v | grep SE
3. Place the bootable diskette you created in the HMC diskette drive, and then reboot the HMC.
   If the diskette does not boot to the BIOS menu, you may need to alter the HMC's startup device list OR press F12 if the Startup Device Menu is enabled, and then boot from the Removable device.
   
   The system should boot to a blue screen that has 3 options:
   1. Flash 73xx-C01 to 20KT46A BIOS. No user input, MTM, S/N.
   2. Flash 73xx-C01 to 20KT46A BIOS. User input required.
   3. Set 73xx-C01 CMOS values supporting 20KT46A BIOS.
    
4. If the machine type and model is set to 7315-C01 or 6792-LPU then select option 1. The BIOS will be flashed. Do not power off the HMC until the update is completed. The HMC will reboot once the flash completes. Do not remove the diskette.
   If the HMC's system planar has been replaced or the lshmc output does not match the label on the front of the HMC, select option 2, and then answer the required prompts:
   - Would you like to update the Serial Number ?
   Update the serial number only if you have replaced the system board of the HMC.

   Answer N for most users.

   - Would you like to update the Machine Type/Model ?

   Answer Y
   For POWER4 HMCs, the model should be 7315C01 or 6792LPU

   For POWER5 HMCs, the model should be 7315C01 or 6792LPU

   The BIOS will be flashed. Do not power off the HMC until the update is completed. The HMC will reboot once the flash completes. Do not remove the diskette.

   If the machine type is not 7315-C01 or 6792, then you have the wrong BIOS version. Remove the diskette and reboot the HMC.

5. After the BIOS has updated:
   1. Select option 3, "Set 73xx-C01 CMOS values supporting 20KT46A BIOS"
   2. After the HMC reboots, remove the diskette.
   3. Select F1 to boot to the IBM setup utility
   4. Verify that Flash EEPROM Revision Level is 20KT46AUS

The BIOS update is complete.