APAR status
Closed as program error.
Error description
Asleft values are not auto-populated for repeatable datasheet for both analog and discreet datasheets. STEPS TO REPRODUCE: 1. First we will need to create a new Data sheet that can be used on the work order. A. Create a new data sheet provide name. Asset Functions section of data sheet. Asset Function =1 Type= Analog Calibration Point= checked Repeatable = checked No adjustment limit = checked Input Information Section Tolerance on Input = Checked Input range from 23 to 56 Output Information Output range from 23 to 56 Tolerance 1 section Status when exceeded = fail Summed EU+ = 34 Applied As = +/- Calibration Points Section Asset Function = 1 Type = Analog Calibration Point = 1 Analog Point Information Section Nominal Input = 23 Desired Output = 23 Tolerances section tolerance 1 from -11 to 57 Once created save and approve the data sheet, we now need to create the new work order to use the data sheet on. 2. Create a new work order and add location to it. 3. On the data sheet tab enter the data sheet created in step 1 4. Under the calibration point section add the As found value of 23 to all needed lines. Place a check mark in the No Adj made check box and save the record, a pop up will show on screen advising that the as found values will be copied to the as left values, press OK. Here notice that not all the lines updated with the needed value, only the first line was updated. EXPECTED RESULTS: That all values would have auto-populated as needed. Reported in Version: Maximo Calibration 7.6.1.0
Local fix
n/a
Problem summary
**************************************************************** * USERS AFFECTED: * * Calibration users * **************************************************************** * PROBLEM DESCRIPTION: * * As Left values are not auto-populating for repeatable data * * sheets. * ****************************************************************
Problem conclusion
The fix for this APAR will be contained in a future release.
Temporary fix
Comments
APAR Information
APAR number
IJ34275
Reported component name
MAXIMO CALIBRAT
Reported component ID
5724R5700
Reported release
761
Status
CLOSED PER
PE
NoPE
HIPER
NoHIPER
Special Attention
NoSpecatt / Xsystem
Submitted date
2021-08-10
Closed date
2023-02-10
Last modified date
2023-02-10
APAR is sysrouted FROM one or more of the following:
APAR is sysrouted TO one or more of the following:
Fix information
Fixed component name
MAXIMO CALIBRAT
Fixed component ID
5724R5700
Applicable component levels
[{"Business Unit":{"code":"BU059","label":"IBM Software w\/o TPS"},"Product":{"code":"SSLKZS","label":"Maximo Calibration"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Version":"761","Line of Business":{"code":"LOB59","label":"Sustainability Software"}}]
Document Information
Modified date:
11 February 2023