IJ34275: CALIBRATION ISSUE ASLEFT VALUES ARE NOT AUTO-POPULATING AS NEEDED FOR REPEATBLE DATASHEET.

APAR status

• Closed as program error.

Error description

• Asleft values are not auto-populated for repeatable datasheet
  for both analog and discreet datasheets.
  
  
  STEPS TO REPRODUCE:
  1. First we will need to create a new Data sheet that can be
  used on the work order.
  A. Create a new data sheet provide name.  Asset Functions
  section of data sheet.
  Asset Function =1
  Type= Analog
  Calibration Point= checked
  Repeatable = checked
  No adjustment limit = checked
  
  Input Information Section
  Tolerance on Input = Checked
  Input range from 23 to 56
  
  Output Information
  Output range from 23 to 56
  
  Tolerance 1 section
  Status when exceeded = fail
  Summed EU+ = 34
  Applied As = +/-
  
  Calibration Points Section
  Asset Function = 1
  Type = Analog
  Calibration Point = 1
  
  Analog Point Information Section
  Nominal Input = 23
  Desired Output = 23
  
  Tolerances section
  tolerance 1 from -11 to 57
  
  Once created save and approve the data sheet, we now need to
  create the new work order to use the data sheet on.
  
  2. Create a new work order and add location to it.
  3. On the data sheet tab enter the data sheet created in step 1
  4. Under the calibration point section add the As found value of
  23 to all needed lines. Place a check mark in the No Adj made
  check box and save the record, a pop up will show on screen
  advising that the as found values will be copied to the as left
  values, press OK. Here notice that not all the lines updated
  with the needed value, only the first line was updated.
  
  
  EXPECTED RESULTS:
  
  That all values would have auto-populated as needed.
  
  
  
  Reported in Version:
  
  Maximo Calibration 7.6.1.0
  

Local fix

• n/a
  

Problem summary

• ****************************************************************
  * USERS AFFECTED:                                              *
  * Calibration users                                            *
  ****************************************************************
  * PROBLEM DESCRIPTION:                                         *
  * As Left values are not auto-populating for repeatable data   *
  * sheets.                                                      *
  ****************************************************************
  

Problem conclusion

• The fix for this APAR will be contained in a future release.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  MAXIMO CALIBRAT

• Fixed component ID

  5724R5700

Applicable component levels