HE00624: 180 DEGREE ANGLE ARC IS NOT CREATED CORRECTLY

APAR status

• Closed as program error.

Error description

• Scenario:
  1. Open the specific model in CATIA: Drafting workbench.
  2. Create angle dimensions by selecting the center lines of
  the holes in the drawing.
  3. Create the 180 degree dimension.
  Problem:
  The 180 degree dimension arc is not created properly.
  Expected result:
  The 180 degree dimension arc should be created properly.
  

Local fix

• empty
  

Problem summary

• Scenario:
  1. Open the specific model in CATIA: Drafting workbench.
  2. Create angle dimensions by selecting the center lines of
  the holes in the drawing.
  3. Create the 180 degree dimension.
  Problem:
  The 180 degree dimension arc is not created properly.
  Expected result:
  The 180 degree dimension arc should be created properly.
  

Problem conclusion

• THIS PROBLEM WILL BE FIXED ON CATIA  VERSION V5R21 level.
  Additional Closure Information:
  Technical explanation of the defect:
  It was not exactly a 180?? arc for CGM which was too accurate.
  It was basically a precision problem.
  Technical explanation of the correction:
  New toolbox method which decides if two lines can be
  considered as the same,
  solves the precision problem.
  Possible by-pass and/or correction limitation:
  none
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 WIN 64

• Fixed component ID

  569165000

Applicable component levels

• R521 PSN

     UP