HE00314: THE VISUALIZED OF EDGE IS NOT CORRECTLY DISPLAY

APAR status

• Closed as Permanent restriction.

Error description

• Scenario: -
  1. Open a specific model file in CATIAV5.
  2. Go to TOOLS/OPTIONS/DISPLAY/VISUALISATION and check ON the
  ???Surfaces Boundaries??? option and set to (5: 1.4 mm)
  3. Observe that some of the edges appear partially black and
  the others appear green (if that is the color applied in
  ???surface boundaries??? option.)
  4. Use the boundary command and select the surface. Observe
  that the surface boundary appears green completely and there
  is no dark edge visible.
  RESULT : The surface boundary does not appear uniform and is
  dark at certain edges.
  EXPECTED RESULT : The surface boundary should be uniform and
  should look the same as after using the ???BOUNDARY??? command.
  

Local fix

• empty
  

Problem summary

• Scenario: -
  1. Open a specific model file in CATIAV5.
  2. Go to TOOLS/OPTIONS/DISPLAY/VISUALISATION and check ON the
  ???Surfaces Boundaries??? option and set to (5: 1.4 mm)
  3. Observe that some of the edges appear partially black and
  the others appear green (if that is the color applied in
  ???surface boundaries??? option.)
  4. Use the boundary command and select the surface. Observe
  that the surface boundary appears green completely and there
  is no dark edge visible.
  RESULT : The surface boundary does not appear uniform and is
  dark at certain edges.
  EXPECTED RESULT : The surface boundary should be uniform and
  should look the same as after using the ???BOUNDARY??? command.
  

Problem conclusion

• THIS PROBLEM IS PERMANENT RESTRICTION
  Additional Closure Information:
  INCIDENT DIAGNOSIS:
  Edges are not correctly displayed
  RESTRICTION EXPLANATION:
  There is a thin face at surface boundary that creates a micro
  flange (length near resolution).
  The very small length of this flange explains behavior of
  visualization (alternating between
  boundary and flange internal edge).
  When we launch boundary command, we create new topology and
  thus, new graphic representation
  with its own priority (different than origin surface edges).
  That's why the visualization seems better.
  BYPASS:
  remove the thin faces.
  

Temporary fix

Comments

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels