HD85056: PART: IMPOSSIBLE TO CREATE THICK SURFACE.

APAR status

• Closed as unreproducible in next release.

Error description

• PART: IMPOSSIBLE TO CREATE THICK SURFACE.
  .
  SCENARIO:
  1. Start CATIA.
  2. Go to Part Design work bench.
  3. Open attached Thick_Surface.CATPart.
  4. Create Thick surface with each Sweep surface.
  Impossible to create with Sweep surface from Line,
  Sketch and Polyline. This is the problem.
  .
  ADDITIONAL INFORMATION:
  Possible to create with Sweep surface from Spline.
  .
  .
  

Local fix

Problem summary

• PART: IMPOSSIBLE TO CREATE THICK SURFACE.
  PART: IMPOSSIBLE TO CREATE THICK SURFACE.
  .
  SCENARIO:
  1. Start CATIA.
  2. Go to Part Design work bench.
  3. Open attached Thick_Surface.CATPart.
  4. Create Thick surface with each Sweep surface.
  Impossible to create with Sweep surface from Line,
  Sketch and Polyline. This is the problem.
  .
  ADDITIONAL INFORMATION:
  Possible to create with Sweep surface from Spline.
  .
  .
  

Problem conclusion

Temporary fix

Comments

• THE PROBLEM WAS SUBMITTED ON CATIA
  VERSION 5 RELEASE 18.
  THIS PROBLEM IS NOT REPRODUCIBLE ON CATIA
  VERSION 5 RELEASE 20 GA LEVEL.
  AND ON V5R19SP05
  Incident Diagnosis:
  PART: IMPOSSIBLE TO CREATE THICK SURFACE.
  .
  Reason:
  Thick surface is now correctly created and result is
  as expected.
  .
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

• Fixed component name

  CATIA V5 NT>XP

• Fixed component ID

  569151000

Applicable component levels

• R519 PSN SP51905

     UP09/07/31 I 1000