HC93530: PARTDESIGN / FILLET WITH TRIM RIBBONS / IMPOSSIBLE FILLET CREATION : RELIMITATION ERROR BECAUSE OF NOTCH CONFIGURATION

APAR status

• Closed as suggestion for future release.

Error description

• Fillet with ribbons trimed not possible (notch problem)
  .
  SCENARIO : (model dependent)
  ---------
  01 Open the CATPart
  02 Create a fillet r=1mm with trim ribbon option as
  indicated in CATPart annotations (2 edges selected)
  03 Compute
   --> Error message : impossible relimitation
  .
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• THIS APAR IS CONSIDERED AS A SUGGESTION FOR IMPROVEMENT FOR
  CATIA.
   .
   INCIDENT DIAGNOSIS:
    ===> PARTDESIGN / FILLET WITH TRIM RIBBONS / IMPOSSIBLE FILLET
  CREATION :
   RELIMITATION ERROR BECAUSE OF NOTCH CONFIGURATION
   .
   JUSTIFICATION FOR DEVLOPMENT REQUEST:
  When you use  Trim ribbons  fillet option you are in a notch
  configuration (the propagation cannot go on after
  relimitation step).
  .
  This is a limitation of fillet algorithm today.
  .
  We have planned an improvement of Trim Ribbons
   in order to succeed in managing such configuration.
  It will be done in a next release .
   .
   ANSWER AND POSSIBLE BY-PASS:
  Decrease slightly the radius value (0.95 for instance).
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels