Question & Answer
Question
We found that the depth of annotation layers are showing differently between in edit mode(viewer) and print preview.
Here are the reproduction steps:
1. Open up a document in Daeja ViewOne Viewer
2. Draw a filled rectangle
3. Draw a line on top on the rectangle.
4. We can see the line is currently shown on top of the rectangle, save the changes
5. However, when we open the document again or print it and check print preview, we found the rendering layer changed, the rectangle is shown on top of the line annotation.
1. Open up a document in Daeja ViewOne Viewer
2. Draw a filled rectangle
3. Draw a line on top on the rectangle.
4. We can see the line is currently shown on top of the rectangle, save the changes
5. However, when we open the document again or print it and check print preview, we found the rendering layer changed, the rectangle is shown on top of the line annotation.
Answer
Here are steps to fix the issue
1 go to Content Navigator's admin desktop or click administration, and select desktops- <yourdesktop>
2 click the Daeja ViewOne tab
3 at additional parameters section, add the following parameter:
name: filenetZOrderEnabled
value: true
name: filenetZOrderEnabled
value: true
[{"Type":"MASTER","Line of Business":{"code":"LOB45","label":"Automation"},"Business Unit":{"code":"BU059","label":"IBM Software w\/o TPS"},"Product":{"code":"SSTTN8","label":"IBM Daeja ViewONE Virtual"},"ARM Category":[{"code":"a8m50000000L2oyAAC","label":"Technote"}],"ARM Case Number":"TS005898402","Platform":[{"code":"PF025","label":"Platform Independent"}],"Version":"5.0.9"}]
Was this topic helpful?
Document Information
Modified date:
29 December 2021
UID
ibm16537298