Product Documentation
Abstract
Instructions for removing Riser card from an xSeries 346 server.
Content
Text from the audio portion of the Riser card removal movie
To remove the riser cards:
- Remove the cover by pressing in the cover release latch and rotate up while sliding the cover the rear approximately one-half inch.
- Lift the cover off and place to the side.
- Remove the low-profile card by pushing out on the two release latch that secures the card.
- Grasp the ends of the card and pull the entire assembly out and place on an ESD protected surface.
- Remove the full-length card: Raise the latch handle to the open position.
- Grasp the ends of the card and pull the entire assembly out and place on an ESD protected surface.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW20Q","label":"xSeries 346"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-58200