Product Documentation
Abstract
Procedures for removing the CD-ROM drive from the xSeries 306 server.
Content
Text from the audio portion of removing the CD-ROM drive movie
To remove the CD-ROM drive:
-
Remove the cover:
- Turn off the server and all attached peripheral devices.
- Disconnect all power cords and all external signal cables.
- Loosen the captive screw on the rear of the server, then slide the cover to the rear and lift it off.
-
Remove the front bezel:
- Press in on the two blue latches and rotate the bezel down and off the server.
Note: That the power and reset button covers may come off with the bezel. The bezel can be removed without removing the top cover.
- Press in on the two blue latches and rotate the bezel down and off the server.
-
Remove the CD ROM drive:
- Remove the single screw securing the interposer card and release the spring retainer and remove it.
- Rotate the left side of the CD-ROM drive up to clear the frame and separate the connector from the CD-ROM drive and lift it out of the server.
- If required the signal cable can be replaced by removing this cover and disconnecting the cable from the system board.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW20K","label":"xSeries 306"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-55244