Virtual tape support commands

Here is a list of commands that are available for using virtual tape and virtual tape volumes.

ADDIMGCLGE

Add Image Catalog Entry: The command adds a virtual tape volume to a tape image catalog.

CHGIMGCLG

Change Image Catalog: The command changes the attributes of a tape image catalog.

CHGIMGCLGE

Change Image Catalog Entry: The command changes the attributes of a virtual tape volume.

CRTIMGCLG

Create Image Catalog: The command creates a tape image catalog to store virtual tape volumes. The command can also create an initial set of virtual tape volumes.

DLTIMGCLG

Delete Image Catalog: The command deletes a tape image catalog.

LODIMGCLG

Load or Unload Image Catalog: The command loads an image catalog on a virtual tape device to make the virtual volumes accessible by the device. The same command is also used to unload an image catalog from a virtual tape device.

LODIMGCLGE

Load/Unload/Mount IMGCLG Entry: The command changes the status of a virtual tape volume within an image catalog.

RMVIMGCLGE

Remove Image Catalog Entry: The command removes a virtual tape volume from a tape image catalog and optionally deletes the virtual tape volume.

WRKIMGCLG

Work with Image Catalogs: The command allows the user to work with a list of image catalogs.

WRKIMGCLGE

Work with Catalog Entries: The command allows the user to work with a list of virtual tape volumes.