IXC247D

Explanation
This system attempted to initialize a couple data
set for the specified type and determined that the data set might
be in use by another sysplex.  Message IXC248E, which precedes this
message, indicates the name of the data set that is possibly in use
by another sysplex.
In the message text: typename
The type of data contained in the couple data set.

System action
Initialization of the couple data set stops until
the operator replies to message IXC247D.

Operator response
Choose one of the following replies: U
To continue initialization of the couple data set. Allowing
initialization to continue on a couple data set that is in use by
another sysplex causes the other sysplex to lose access to the data
set, which might cause the system(s) in that sysplex to enter a wait
state.

D
To stop initialization of the couple data set. If initialization
is stopped, either the data set will not be brought on as an alternate
couple data set or the type will not be started.

If an incorrect reply is entered, the system
issues message IXC208I to notify the operator of the error.  The system
then reissues message IXC247D.
Notify the system programmer.

System programmer response
This message occurs because the couple
data set is or was being used by another sysplex, or the couple data
set was previously used by this sysplex but there is no longer a record
of its use.

Source
Cross System Coupling Facility (SCXCF)

Module
IXCL1OWN

Routing code
1,2

Descriptor code
Either 2 or 5