IXG217E

Explanation
An attempt by IXGLOGR to allocate a new instance
of a staging data set for log stream logstream failed.
If you found an old instance of the staging data set and could not
delete or reallocate it, a problem might exist on the volume specified
in the message. ON VOLUME xxxxxx included
in the message indicates the volume on which the staging data set
resides. If ON VOLUME ?????? is included in the message, you
could not obtain the duplicate staging data set volume from the catalog.
In
the message text: logstream
is the name of the log stream.
alloctext
One of the following:blanks
Unable to allocate a New Staging data set.
DUPLICATE NAME FOUND
Unable to allocate a new staging data set. A duplicate data set
could not be allocated for the purpose of deleting it. This might
be because the volume is not available.

datasetname
is the data set name.
voltext
One of the following:blanks
A volume serial is not available.
ON VOLUME
A volume serial is available.

volume
is the volume name or ??????.

System action
System logger will not be able to use the staging
data set. The impact depends on the function requesting the staging
data set.
When Connect is requested, IXGCONN is rejected with
Return Code 8-80C. Message IXG231I may also be issued.
When
system logger encounters an I/O or access error with a staging data
set, and a new staging data set 12 cannot be obtained, then for a
CF-based log stream local buffers will be used to duplex the log stream
data. Message IXG255I may also be issued.  For a DASDONLY log stream,
the log stream will be disconnected. An ENF48 signal will be issued
with event indicator IxgenfLogstreamsNotAvailable, event reason IxgenfReqLogResNotAvail,
and specific reason IxgenfStgAllocErr set on. Message IXG216I may
also be issued.  When a rebuild fails and system logger is unable
to resume  using the original structure, then an attempt will be made
to ensure the log data is duplexed in staging data sets to minimize
the potential for a loss of data condition.  When a new staging data
set cannot be allocated to keep the duplexed data, then the likelihood
for a loss of data condition remains.  Message IXG232I may also be
issued.  When a rebuild completes and the duplexmode is set to conditional,
system logger may attempt to duplex to a staging data set versus using
local buffers. If the staging data set cannot be obtained, then local
buffers will continue to be used.  Message IXG113I may also be issued.
Other System logger messages may be issued for this log stream or
staging data set. Other components may have issued diagnostic messages
as well.

Operator response
Notify the system programmer.

System programmer response
Check for I/O error messages and allocation
error messages and correct the problem. After the problem has been
resolved, it may be necessary to cause the application to reconnect
to the log stream.

User response
None.

Programmer response
None.

Source
System logger (SCLOG)

Module
IXGA1AUS

Routing code
10

Descriptor code
4