Explanation
reason is one of the following:
- PARMLIB MEMBER NOT FOUND.
- PARMLIB I/O ERROR.
- SYNTAX ERROR - MESSAGE(S) FOLLOW.
- OTHER PARMLIB ERROR
- PARMLIB BUFFER IS FULL
- PARMLIB CANNOT BE READ
- DYNAMIC ALLOCATION OF PARMLIB FAILED
Information needed to process the TRACE CT command could not be
obtained from the PARMLIB member specified. In the message text:
- xxxxxxxx
- The parmlib member
System action
The system ignores the operator command.
Operator response
Do the following:
- If the parmlib member could not be found, then verify that the
member exists before reentering the command.
- If there was an I/O error, have the system programmer correct
the error.
- If there was a syntax error, then see the operator response for
the error message following this message. Also, an attempt will be
made to continue parsing beyond the error point to try to elicit all
syntax error messages that may apply. If multiple subs are specified,
the system recovers from this error and continues with the next sub.
System programmer response
Identify and correct the error before telling the operator to reenter
the command.
Source
Module
Routing code
Descriptor code