Explanation
In the message text, text is
one of the following:
PDSE MONITOR IS HALTED
Issue V SMS,PDSE RESTART to activate
or
or
PDSE MONITOR IS ACTIVE
++ DISPLAY MODE ACTIVE
++ DUMP NEXT MODE ACTIVE
++INVOCATION INTERVAL: iiiiii SECONDS
++SAMPLE DURATION: dddddddd SECONDS
The operation
parameters for the PDSE monitor function may have changed. The new
operational parameters are displayed, where:
- HALTED
- The state where the monitor has been stopped because of a previous
error in the monitor.
- INACTIVE
- The state where the monitor is not running because the SMS parameter
or the V SMS,PDSE,MONITOR,OFF command was issued.
- ACTIVE
- The state where the monitor is running normally.
- ++ Display Mode Active
- Monitor displays message IGW031I for all possible error conditions
discovered.
- ++ Dump Next Mode Active
- Monitor takes an SVC dump for the next possible error condition
discovered.
- iiiiiiii
- The number of seconds between monitor cycles.
- dddddddd
- The number of seconds an error condition must exist for it to
be detected.
The parameters changed because:
- The system IPLed.
- The V SMS,PDSE,MONITOR command was issued.
- The SET SMS=xx command was issued and the IGDSMSxx member
contains the PDSE_MONITOR parameter.
Use the V SMS,PDSE,MONITOR command or the PDSE_MONITOR
parameter of the IGDSMSxx parmlib member to change the operational
parameters.
System action
Operator response
System programmer response
None; the message is informational.
Programmer response
Source
Storage Management Subsystem (SMS)
Module