MAXIMUM NUMBER OF SUBSYSTEMS EXCEEDED. text.
Explanation
text is one of the following:
- SUBSYS name IS IGNORED.
- SET SMF TERMINATED. OLD OPTIONS REMAIN IN EFFECT
One of the following occurred:
- SUBSYS name IS IGNORED.
- During IPL, SMF found that more than four subsystem name parameters
were specified in the SMFPRMxx parmlib member. The system ignores
the additional subsystem names. The second line of the message appears
for each rejected parameter.
- SET SMF TERMINATED. OLD OPTIONS REMAIN IN EFFECT
- SET SMF command processing found that the total of the input subsystem
name parameters and the subsystem names already in the system is greater
than four. SMF rejects the command.
If the system already contains
four subsystem names, use the SET SMF command to change the subparameters
on an existing subsystem, but you cannot replace an existing subsystem
name with a new one. To do this, reIPL the system.
System action
If the message was issued during IPL, SMF ignores
the subsystem names appearing in the message.
If the message
was issued in response to a SET SMF command, processing ends. The
old SMF options remain in effect.
Operator response
If you want to replace an existing subsystem
name with a new one, reIPL the system using an SMF member of SYS1.PARMLIB
that contains the correct subsystem names.
Source
System Management Facilities (SMF)
Module
Routing code
Descriptor code