Explanation
error is one of the following:
- SCREEN SIZE EXCEEDED
- DISPLAY IN OR ABOVE AREA
- AREA TOO SMALL
- TOO MANY AREAS DEFINED
A CONTROL A command requested that the system define or
redefine screen areas.
In the message text:
- SCREEN SIZE EXCEEDED
- The sum of the lengths of the areas defined exceeded the size
of the message area on the console for which the definition was requested.
- DISPLAY IN OR ABOVE AREA
- The error was one of the following:
- The requested redefinition affects an area with a display in or
above it. Any area definition requested while a display is on the
screen may differ from the previous definition only in regard to display
areas above the area in use.
- The operator tried to clear the screen of all area definitions
with a CONTROL A,NONE, but one of the areas contained a display.
- AREA TOO SMALL
- An attempt was made to define a display area of less than four
lines.
- TOO MANY AREAS DEFINED
- An attempt was made to define more than 11 display areas on a
console; 11 is the maximum number.
- COMMAND ISSUED IS command
- command is the text of the command that was
originally entered.
System action
The system rejects the command.
Operator response
If the error occurred for a CONTROL A,NONE
command, erase the display(s). Enter the command again.
If
the error occurred for a CONTROL A command other than CONTROL A,NONE,
correct the command. Enter it again, if desired.
If the CONTROL
command fails again, save the hard-copy log and contact the system
programmer.
System programmer response
Search problem reporting data bases
for a fix for the problem. If no fix exists, contact the IBM® Support
Center. Provide the hard-copy log.
Source
Module
IEE2003D, IEE6803D, IEE6903D
Routing code
Descriptor code