SOME MESSAGES NOW SENT TO HARDCOPY ONLY --or-- SAME MESSAGES
ISSUED FROM THE FOLLOWING
Explanation
The system successfully processed a VARY or CONTROL
V command. The system now issues the following messages only to hardcopy:
- Broadcast messages
- Informational messages with certain routing codes
- Informational messages with certain message levels
The system does not display these messages on any console.
The
system may issue this message if a console fails or if a
system leaves the sysplex.
The command entered was one of the
following:
- VARY CONSOLE
- VARY ONLINE
- VARY OFFLINE
- CONTROL V,LEVEL
System action
The system continues processing. The system issues
message CNZ4100I to the console on which the operator entered
the command. Message CNZ4100I provides information about
the message loss.
Operator response
Do the following, if you want messages displayed
on consoles:
- Enter one or more VARY CONSOLE commands to receive missing informational
messages, to receive messages with the routing codes for which you
previously were not receiving messages.
- Enter DISPLAY C,HCONLY to see what types of messages are being
lost.
- For any active console, enter VARY CN(xxx),ROUT=ALL,MSCOPE=*ALL
and CONTROL V,LEVEL=ALL to resolve the problem.
- If running in local mode, enter the VARY CN(xxx),ROUT=ALL command
to resolve the problem.
- If this message was issued because a system left the sysplex,
bring that system, or another system, into the sysplex. This may relieve
the condition.
Source
Module
Routing code
Descriptor code