IEE740I
SLIP TRAP ID=xxxx SET BUT DISABLED DUE TO TRAP ID=yyyy

Explanation

A valid SLIP SET command requested that the system set a non-ignore program event recording (PER) trap. However, another non-ignore PER SLIP trap is already enabled. The system enables only one non-ignore PER trap at any particular time.

In the message text:
ID-xxxx
The SLIP trap identifier specified on the SLIP command.
ID-yyyy
The SLIP trap identifier of the trap currently enabled.

System action

SLIP command processing disables the new SLIP trap before setting it.

Operator response

Notify the system programmer. Enter the SLIP commands specified by the system programmer.

System programmer response

If SLIP trap ID=xxxx should be enabled, ask the operator to issue two SLIP MOD commands, as follows:
  1. One command to disable trap ID=yyyy
  2. A second command to enable trap ID=xxxx

Source

SLIP

Module

IEECB905

Routing code

*,10

Descriptor code

5

Parent topic: IEE messages (IEE700I - IEE892I)