Explanation
In response to a reconfiguration request, the system
tried to reconfigure a system element or storage-class memory (SCM). The
system encountered an internal error and tried to recover, but the
recovery was not complete. In the case of a system element request,
the system element identified in the message could not be varied.
In
the message text:
- syselem
- The system element for which the CONFIG or VARY command requested
reconfiguration. syselem is one of the following:
- CHP(xx)
- CPU(z)
- CORE(z)
- EXTENDED STORAGE ELEMENT (x)
- SIDE(x) REAL STORAGE [ELEMENT (x)]
- COMMAND PROCESSOR ERROR
- A problem in the CONFIG command processor.
- CONFIG REAL STORAGE COMMAND PROCESSOR ERROR
- A problem in the CONFIG command for central (real) storage.
- CONFIG SCM COMMAND
PROCESSOR ERROR
- A problem in the CONFIG SCM command
processor.
System action
In most cases, the system abnormally ends the
current task with abend code X'0B7'.
Depending on the
message text, the system does the following:
- CHP(xx)
- The system did not reconfigure channel path xx.
If the CONFIG command requested reconfiguration of a range of channel
paths, the system continues reconfiguration for the next requested
channel path. The system writes a logrec data set error record and
an SVC dump.
- CPU(z)
- CORE(z)
- REAL STORAGE
- REAL STORAGE ELEMENT
- SCM
- The system ends reconfiguration processing. The system writes
a logrec data set error record and an SVC dump.
Operator response
Enter the DISPLAY M command to determine the
status of system elements and SCM in
the system.
Enter a CONFIG command naming only the element specified
in the message text. If the CONFIG command succeeds and your original
CONFIG command included additional elements, enter the original command
again. If the original command fails again, contact hardware support.
Source
Module
IEEVCHPR, IEEVSTEE, IEEVSTPE, IEEVIOSR
Routing code
Descriptor code