Explanation
A reconfiguration request asked that the system
reconfigure a channel path offline, but this channel path represents
the last channel path to one or more devices. If a CONFIG command
specified the UNCOND parameter, any devices listed in the message
text are allocated or assigned to JES3.
In the message text:
- xx
- The channel path for which the request was entered.
- dev
- The device number or numbers associated with the specified channel
path.
System action
Depending on the command entered, one of the following:
- If a CONFIG CHP(xx),OFFLINE command was entered,
the system ends reconfiguration processing for channel path xx.
- If a CONFIG CHP OFFLINE command specified a range of channel paths,
the system continues reconfiguration processing for the next requested
channel path.
Operator response
Do one of the following:
- If the CONFIG command did not specify the UNCOND parameter, enter
the CONFIG command again, specifying UNCOND, to reconfigure the channel
path or processor offline.
- If the CONFIG command specified the UNCOND parameter, do one of
the following:
Source
Module
Routing code
Descriptor code