Explanation
While the system was performing program function
key (PFK) processing to initialize a console, an error occurred.
- name
- The name of the console that was being initialized when the failure
was detected.
- text
- One of the following:
- NO PFK TABLES REQUESTED
- The CONSOLxx parmlib member did not specify
the name of a PFK table to be used for console.
- TABLE tttttttt NOT FOUND
- The CONSOLxx parmlib member specified tttttttt as
the name of the PFK table that should be used for the console, but tttttttt was
not one of the PFK tables that was available for use.
- PFK TABLE INITIALIZATION NOT COMPLETE
- The CONSOLxx parmlib member requested a PFKTABxx member
to be used to define PFK tables for consoles. Initialization of the
PFK tables was not complete when the specified console was being initialized.
System action
The system uses the IBM® default
PFK definitions for the console.
Operator response
If desired, do the following:
- Enter the SET PFK command to define the available PFK tables,
if the IBM default PFK definitions are not appropriate.
- Enter the SET PFK command to define the available PFK tables,
- Enter the CONTROL N,PFK command to specify the PFK table to be
used for the console.
System programmer response
Depending on the message text, do
the following:
- NO PFK TABLE REQUESTED
- Update the CONSOLxx parmlib member for the
console to include a PFK table name to be used.
- TABLE tttttttt NOT FOUND
- Check the PFK table name specified for the console in the CONSOLxx parmlib
member. If the table name is incorrect, change it to a valid PFK table
name. If the table name is correct, ensure that the PFK table is defined
in the PFKTABxx parmlib member.
- PFK TABLE INITIALIZATION NOT COMPLETE
- No response necessary. Ask the operator to enter CONTROL N,PFK
when the system has completed initialization.
Source
The following:
- Communications task (COMMTASK)
- Device independent display operator console support (MCS)
- Master scheduler
Module
IEAVC701, IEECVFTU, IEE8C03D
Routing code
Descriptor code