Explanation
Device sxxxx Status: status
direction routing information follows:
Switch Domain=dd, Type=switch-type
Group
Port Type From To Agg Dyn Speed Misc
aa Entry Chan Chan nn nn xxxG Dynamic
Exit CU CU .. .. Static Alt=nn
ddaa ddaa
Agg-nn Agg-nn
Mult Dyn-nn
The
message text that is displayed when using the HEALTH keyword is shown
below. The device/CHPID information will not be displayed.
Health information follows:
Fabric Health=fabric-health-info
Switch Domain=dd, Health=switch-health-info
%Util %Delay Error Count Opt Signal
Port Health Trn/Rcv Trn/Rcv Trn/Recv Trn/Recv
aa port-health-info nnn/nnn nnn/nnn nnnnn/nnnnn ±nnnn/±nnnn
- status
- One of the following:
- ONLINE
- OFFLINE
- NOT IN SYSTEM
- SUBCHANNEL STATUS NOT AVAILABLE
- SUBCHANNEL IN PERMANENT ERROR
- DEVICE NOT AVAILABLE
- DEVICE IS BOXED
- ALIAS OF BASE bdev
- UNBOUND ALIAS
- HYPERPAV ALIAS
- HYPERPAV ALIAS OF BASE bdev
- ALIAS IS BOXED: RESIDUAL DATA FOLLOWS
- UNUSABLE HYPERPAV ALIAS
- CHANNEL PATH NOT INSTALLED
- SPECIAL
- direction
- One of the following:
- Source to destination
- Destination to source
- dd
- Domain ID of the attached switch.
- switch-type
- One of the following:
- Only Director
- Source Director
- Intermediate Director
- Destination Director
- aa
- Port ID.
- ddaa
- Attached port address when not attached to a channel (Chan) or
control unit (CU), or attached port is not an aggregate, or an individual/AGN
(Mult) port, or a dynamic path group (Dyn-nn).
- nn
- Number of static aggregate ports (Agg-nn) or
dynamic path groups (Dyn-nn).
- fabric-health-info
- 24-character fabric health summary report defined by the switch.
If the fabric is healthy, No health issues is displayed.
- switch-health info
- 24-character switch health summary report defined by the switch.
If the switch is healthy, No health issues is displayed.
- port-health-info
- 24-character port health summary report defined by the switch.
If the port is healthy, No health issues is displayed.
If the ROUTE or HEALTH data cannot be obtained,
the following message will be displayed in place of the previous data:
ROUTE INFORMATION FOR DEVICE sxxxx CANNOT BE DISPLAYED:
reason
Where reason can
be one of the following:
- CHANNEL NOT CONNECTED TO A SWITCH
- The channel path is not switch connected.
- SWITCH xxxx DOES NOT SUPPORT ROUTE INFORMATION
- The switch does not support the routing information.
- SWITCH xxxx BUSY WITH ANOTHER REQUEST
- The switch is busy processing a previous request.
- SWITCH xxxx ATTACHED TO CHPID chp IS
TEMPORARILY NOT AVAILABLE
- No device defined to the specified channel device is boxed.
- DEVICE IS NOT CONFIGURED WITH A 2 BYTE LINK ADDRESS
- The device is not defined with a two-byte link address in the
IODF.
- UNKNOWN ERROR
- The error cannot be determined.
Note: When ROUTE=BOTH is requested, it is possible
that only one direction may contain valid data. This data will be
displayed, and "no port information provided" will be displayed for
the other direction.
Module
Routing code
Descriptor code