Explanation
A SLIP SET or SLIP MOD,ID=
xxxx,ENABLE
command specified a non-ignore PER trap. The evaluated range exceeds
1MB or wraps. The RANGE parameter might be incorrect. Note that
if the specified starting address of the range is greater than the
ending address, the requested RANGE wraps from the end of storage
to the beginning and includes all storage outside of the specified
values. In the message text:
- xxxx
- The SLIP trap identifier specified on the SLIP command.
- addr1,addr2
- The first and last range addresses specified on the SLIP command.
System action
The system continues other processing.
Note: When
this message is issued for a SLIP MOD,ID=xxxx,ENABLE
command, failure of the operator to reply to the message will keep
all other SLIP commands from being processed.
Operator response
If the range is as desired, enter OK. The
system will activate the trap.
If the range is incorrect, enter
CANCEL:
- For a SLIP SET trap, CANCEL deletes the trap.
- For a SLIP MOD trap, CANCEL deletes only this trap. Other traps
may be activated if the SLIP MOD command used a wildcard character
in the ID parameter or specified ALL.
Module
Routing code
Descriptor code