Explanation
A SLIP command was entered with an incorrect or
missing parameter.
In the message text:
- text
- An indication of the incorrect or missing parameter:
- ADDRESS RANGE
- The command incorrectly specified, or did not specify, the address
range. An address range is required for the type of trap being defined.
Address ranges are defined on the following parameters:
- RANGE
- LPAMOD
- LPAEP
- PVTMOD
- PVTEP
- NUCMOD
- NUCEP
- RANGE KEYWORD
- The command incorrectly specified, or did not specify, the RANGE
parameter. This parameter is required for the type of trap being
processed.
- TARGETID
- The command contained ACTION=TARGETID, but did not specify a target
identifier.
- {xxxxxxx|COMMAND}
- The type of SLIP command that was specified. If COMMAND appears,
the system could not determine the type of SLIP command.
- ID=xxxx
- The SLIP trap identifier specified on the SLIP command.
- COMMAND
- No SLIP trap identifier was specified on the SLIP command. The
word COMMAND is substituted.
System action
The system waits for the operator to reply.
Operator response
Do one of the following:
- Reply REPLY id,prm to specify the missing or incorrect parameter,
where prm is the required parameter. If the message
contains TARGETID, the parameter is the target identifier of the target
trap.
- Reply REPLY id,CANCEL to cancel the original SLIP command.
id is the identifier preceding the
message number.
Source
Module
Routing code
Descriptor code