Explanation
The system did not activate the first SLIP trap
in a dynamic PER activation chain because the TARGETID parameter of
one trap was incorrect. In the message text:
- xxxx
- The SLIP trap identifier specified on the SLIP command with the
incorrect TARGETID parameter.
- text
- The reason the TARGETID was not correct is one of the following:
- TARGETID CAUSES A CIRCULAR DYNAMIC PER ACTIVATION CHAIN.
- The TARGETID of one trap in the chain references another trap
that, in turn, refers back to the first trap, directly or indirectly.
- TARGETID CORRESPONDS TO A nnnn TRAP.
- Where nnnn is one of the following:
These traps do not participate in dynamic PER activation chains.
System action
The system does not active the SLIP traps in the
dynamic PER activation chain. The system continues with other processing.
Operator response
Contact the system programmer.
System programmer response
Correct the problem indicated by the text.
Ask the operator to enter the SLIP commands again.
Source
Module
Routing code
Descriptor code