EDG2106D

Explanation
During initialization, the DFSMSrmm subsystem found
that the journal does not match the current control data set because The control data set was restored without using the journal

or The journal selected by the DFSMSrmm parameters has changed and
is not empty

System action
The current task waits for a reply.

Operator response
Reply as described in the following table.
When the operator replies
For the action
The result is
C
Cancel
DFSMSrmm stops.
D
Disable
DFSMSrmm disables the journal and completes initialization.
Updates can be made to the DFSMSrmm control data set, but no further
updates to the journal take place until the BACKUP function of inventory
management is run to back up the control data set and to clear the
journal.
L
Lock
DFSMSrmm completes its initialization but no updates to the
DFSMSrmm control data set are allowed until the DFSMSrmm EDGHSKP utility
with the BACKUP parameter is run to back up the control data set and
to clear the journal.
Any reply other than C, L, or D.
Other than CANCEL, LOCK, or DISABLE.
DFSMSrmm reissues this message to prompt the operator for the
correct response: C, L, or D.

System programmer response
Instruct the operator to respond as
follows:
If the mismatch
The operator reply is
is caused by an incomplete restore
C. Then repeat the restore using both the control data set
backup and the correct journal, then restart DFSMSrmm.
is caused by an incorrect journal
C. Then restart DFSMSrmm with the correct journal.
cannot be resolved immediately
L or D. Then request an inventory management - BACKUP of the
DFSMSrmm control data set. Clear the journal to avoid possible data
integrity problems that might occur when DFSMSrmm control data set
updates are not journaled.

You must reply to this message before the DFSMSrmm control
data set can be backed up. The control data set remains reserved until
you reply to this message.

Source
DFSMSrmm

Module
EDGMFIO

Routing code
1,3

Descriptor code
2