EDG2103D

Explanation
The DFSMSrmm subsystem encountered an error performing
I/O to the journal. If the journal is full, DFSMSrmm issues message
EDG2104E.

System action
The current task waits for a reply.

Operator response
The operator replies
For the action
And the result is
D
Disable
DFSMSrmm completes the DFSMSrmm control data set update and
disables the journal. Updates can be made to the DFSMSrmm control
data set, but DFSMSrmm does not allow further updates to the journal
until BACKUP is run to back up the DFSMSrmm control data set and to
clear the journal. Forward recovery might not be possible because
some journal records are missing as a result of the journal being
disabled. If there are inconsistencies in the DFSMSrmm control data
set after the restore is performed, run the DFSMSrmm utility EDGUTIL
VERIFY(ALL) to validate the control data set.
I
Ignore
DFSMSrmm completes the DFSMSrmm control data set update. DFSMSrmm
does not update the journal and issues this message for subsequent
updates. Forward recovery might not be possible because some journal
records are missing as a result of the journal being disabled.
L
Lock
DFSMSrmm does not allow updates to the DFSMSrmm control data
set until BACKUP is run to back up the DFSMSrmm control data set and
to clear the journal. DFSMSrmm fails any requests that result in an
update to the DFSMSrmm control data set. For tape open and close requests,
DFSMSrmm issues WTOR EDG4000D which prompts the operator for a RETRY
or CANCEL reply. DFSMSrmm issues EDG3205E in response to a DFSMSrmm
TSO subcommand request. If the error occurred during inventory management,
the utility issues a message and processing stops.
R
Retry
DFSMSrmm retries the same DFSMSrmm control data set update
and the journal update. This reply might correct an update failure
resulting from an I/O error caused by some temporary hardware fault
that has now been cleared. If the retry fails, or if the original
update failed because the journal was full, then select one of the
other replies to this message.

System programmer response
  Use the DFSMSrmm EDGHSKP utility
with the BACKUP parameter to back up the DFSMSrmm control data set
and clear the journal. You must reply to this message before the DFSMSrmm
control data set can be backed up. The control data set remains reserved
until you reply to this message. The recommended reply is L. If the
journal is deleted and reallocated to recover from the error, you
must stop and start DFSMSrmm before journaling can resume.

Source
DFSMSrmm

Module
EDGMFIO

Routing code
1

Descriptor code
2