EDG0303D

Explanation
DFSMSrmm called an installation exit and detected
that the exit either abnormally ended or set an unsupported return
code.
In the message text: exit_name
This is the name of the installation exit that failed.
volser
This is the volume serial number that DFSMSrmm is processing.
jobname
This is the name of the job that is running.
stepname
This is the name of the current job step.

System action
DFSMSrmm waits for the operator to reply to this
message.

Operator response
Reply as described in the following table.
Operator Reply
Result
CANCEL
DFSMSrmm fails the current request, but processes all other
requests.
DISABLE
DFSMSrmm continues with the current request. All future requests
are processed by DFSMSrmm without use of the installation exit. The
installation exit is disabled. Tape processing continues. If you reply
DISABLE, refer to message EDG0304I which describes possible consequences.
CONTINUE
DFSMSrmm processes the current request ignoring the failure
of the installation exit. All future requests will be processed using
the installation exit. DFSMSrmm issues EDG0304I in response to the
reply.
RETRY
DFSMSrmm retries the current request. Before replying RETRY,
first refresh the DFSMSrmm installation exits. To refresh the exits,
enter the following operator command: MODIFY DFRMM,REFRESH EXITS

DFSMSrmm reissues this message if your reply is not: CANCEL,
DISABLE, CONTINUE, or RETRY.

System programmer response
After correcting the error that caused
your installation exit to fail, refresh LLA if necessary, then issue
the following operator command to refresh the DFSMSrmm installation
exit: MODIFY DFRMM,REFRESH EXITS

Source
DFSMSrmm

Module
EDGCMUX

Routing code
1,3

Descriptor code
3