CNZ4103I timehmsp CONSOLE DISPLAY GENERIC=generic SYSTEM APPLID SMCS STATUS [APPLID* GENERIC*] sysname applid status [appluse genuse] [* CURRENT NAME IN USE BY SYSTEM]
Explanation
In response to a DISPLAY CONSOLES,SMCS command, this message displays the SecureWay Communications Server APPLID for SMCS and the SMCS status for each system in the sysplex or the current system if not in a sysplex.
In the message text:
- timehmsp
- The time that the message was issued.
- generic
- The SMCS VTAM® generic id. If a VTAM generic id is not in use by SMCS or the system is not in a sysplex, *NONE* will be displayed.
- sysname
- The name of the system.
- applid
- The SecureWay Communications Server APPLID for SMCS. If SMCS is not installed, applid will be blank.
- status
- One of the following:
- ACTIVE
- SMCS is connected to SecureWay Communications Server and SMCS consoles can be used.
- INACTIVE
- SMCS is not active at this time. SMCS has failed and has completed termination cleanup processing.
- INITIALIZING
- SMCS is beginning to initialize.
- WAITING FOR VTAM
- SMCS is attempting to communicate with VTAM but VTAM is not available at this time.
- WAITING FOR SMCS APPLID ACTIVATION
- SMCS is communicating with VTAM but the APPLID that SMCS is to use has not been activated by VTAM. SMCS is waiting for VTAM or the operator to activate the APPLID.
- SHUTTING DOWN
- SMCS has been requested to shut down. SMCS will cleanup and wait for the SMCS APPLID to become active.
- NOT INSTALLED
- No SMCS APPLID was specified in the CONSOLxx member of Parmlib so SMCS consoles can not be used on this system.
- SMCS TERMINATING - FAILURE
- SMCS has failed and is attempting to clean up. Depending on the error, SMCS might attempt to restart itself.
- appluse
- The SecureWay Communications Server APPLID in use. appluse is optional. If appluse is different from applid, it will be displayed.
- genuse
- The SMCS VTAM generic id in use. genuse is optional. If genuse is different from generic, it will be displayed.
System action
The command is processed.
Operator response
Possible actions for the following values of status:
- WAITING FOR VTAM
- If VTAM should be available and it is not, perform the necessary actions to activate VTAM.
- WAITING FOR SMCS APPLID ACTIVATION
- If SMCS is to be active, and VTAM has fully initialized, activate the SMCS APPLID (via the VARY NET,ACT,ID=applid command). If the applid has not been defined to VTAM, notify the system programmer to define the SMCS application.
- NOT INSTALLED
- If SMCS is to be active, have your system programmer specify an SMCS APPLID in the CONSOLxx member of Parmlib. The system will then have to be re-IPLed to activate SMCS.
System programmer response
None.
Module
CNZK1DCM
Source
Consoles (SC1CK)
Routing Code
*
Descriptor Code
5,8,9