CNZ2600I AUTO-REPLY POLICY action
Explanation
One of the following conditions has occurred:
- A SET AUTOR= command was issued to activate or modify the auto-reply policy.
- A SETAUTOR OFF command was issued to deactivate the auto-reply policy.
- During IPL, the operator replied AUTOR= to message IEA101A.
- The IEASYSxx parmlib member that was used during IPL contained AUTOR=.
- The default parmlib member AUTOR00 was used.
In the message text:
- action
- One of the following:
- ACTIVATED
- The auto-reply policy has been activated.
- DEACTIVATED
- The auto-reply policy has been deactivated.
- DEACTIVATED – OUTSTANDING WTORS WILL NOT BE AUTO-REPLIED
- The auto-reply policy has been deactivated and outstanding WTORs will no longer be auto-replied.
- ALREADY DEACTIVATED
- The auto-reply policy was already deactivated.
- MODIFIED
- The auto-reply policy has been modified.
- MODIFIED - OUTSTANDING WTORS USING PREVIOUS POLICY
- The auto-reply policy has been modified and there were outstanding WTORs that were being monitored. These outstanding WTORs will use the rules from the previous policy.
- ATTEMPTING TO USE AUTOR=00
- Auto-reply processing attempts to use the AUTOR00 parmlib member.
System action
If activated, the system monitors WTORs and automatically replies when appropriate. If deactivated, the system no longer automatically replies to WTORs.
Operator response
None.
System programmer response
None.
Module
CNZK1SAR, CNZK1TAR, IEAVNPAR
Source
Consoles (SC1CK)
Routing Code
*, Note 13
Descriptor Code
5