A QUERY command was issued with the CONTROLDATASETS parameter. This message contains information about the VSAM index for the migration control data set (MCDS), backup control data set (BCDS), or offline control data set (OCDS). The message is issued once for each control data set (CDS.)
The total space allocated in kilobytes is kbytes. This figure is based on the amount of space between the beginning and end of the index (high allocated). If the index is defined so that it can extend, this value increases. This value is used as the denominator in the calculation of the %. FULL; see below.
The percentage of space used in the data set is percent
The numerator is the amount of space between the beginning of the data set and the high-used point in the data set.
The denominator is the total space (TOTAL SPACE) in the data set as described above.
This value may vary in size if the data set is defined so it can extend.
The installation-specified threshold percentage of occupancy is thresh specified by the SETSYS MONITOR command which, when exceeded, causes the issuance of attention message ARC0911E.
DFSMShsm processing continues.
DFSMShsm