DS DASD BACKUP TASKS={number of tasks}, DS TAPE BACKUP TASKS={number
of tasks}, DEMOUNTDELAY={delay minutes}, MAXIDLETASKS={number of idle
drives}, DS BACKUP MAX DASD SIZE={kbytes}, DS BACKUP STD DASD SIZE={kbytes},
SWITCHTAPES TIME={time to demount idle tapes}, PARTIALTAPE={MARKFULL
| SETSYS | REUSE}, GENVSAMCOMPNAMES={YES | NO}
Explanation
A QUERY command was issued with the BACKUP or
SETSYS parameter. DFSMShsm issues
this message to describe the current parameter settings for the data
set backup function.
The maximum number of data set backup
tasks to run concurrently to either tape or DASD is referred to as
TASKS.
- DS DASD BACKUP TASKS
- The number of data set backup tasks that may use ML1 DASD as the
backup target device.
- DS TAPE BACKUP TASKS
- The number of data set backup tasks that may use tape as the backup
target device.
- DEMOUNTDELAY
- The number of minutes to delay the demount of a tape after it
has no work to do. The number of drives that can delay tape demount
is limited by MAXIDLETASKS.
- MAXIDLETASKS
- The number of drives for which a demount of a tape is to be delayed
after it has no more data sets to be backed up to it.
- DS BACKUP MAX DASD SIZE
- The size in kilobytes of the largest data set that may be directed
to ML1 DASD for WAIT requests that do not specify the TARGET keyword.
- DS BACKUP STD DASD SIZE
- The size in kilobytes of a small data set. Small data sets are
directed to ML1 DASD for WAIT requests that do not specify the TARGET
keyword when a tape task is not immediately available to process the
request.
- SWITCHTAPES TIME
- The time that is specified for the DEFINE SWITCHTAPES command.
If 0 is displayed, the data set backup tape will not be demounted
at any specific time of the day. If a time is displayed, the data
set backup tapes will be demounted at that time. If AUTOBACKUPEND
is displayed, the data set backup tapes will be demounted at the end
of AUTOBACKUP.
- PARTIALTAPE
- The action to be taken on partial tapes upon the SWITCHTAPES demount.
If MARKFULL is displayed, DFSMShsm will mark the data set backup tapes
full upon SWITCHTAPES demount. If REUSE is displayed, DFSMShsm will
not mark the tapes full but will keep them available for remount.
If SETSYS is displayed, DFSMShsm will take the action specified
in the SETSYS PARTIALTAPE command.
- GENVSAMCOMPNAMES
-
If GENVSAMCOMPNAMES=YES, DFSMShsm indicates that DFSMSdss should generate new
data and index component names when processing a backup with NEWNAME
request and the data set being backed up is VSAM and the newname data
set is either migrated or uncataloged.
If GENVSAMCOMPNAMES=NO, DFSMShsm fails
a backup with NEWNAME request when the data set being backed up is
VSAM and the newname data set is either migrated or uncataloged.
System action
DFSMShsm processing continues.
Programmer response