ESTAB. PAIR FAILED- DEVICES NOT IN SUSPEND MODE
Explanation
The CESTPAIR MODE(RESYNC) command
failed to establish the PPRC volume pair. The MODE(RESYNC) parameter
is not valid unless the following conditions are met:
- The specified primary and secondary devices are in SUSPEND state
- The device specification of the primary and secondary devices
matches that of the primary and secondary devices of an already established
PPRC volume pair in SUSPEND state.
System action
System programmer response
Issue the CQUERY command
to verify the status of each device and determine whether the specified
primary and secondary devices correspond to the same volume pair specification.
Then, determine which of the following actions to perform next:
- If the volume pair is active (PENDING or DUPLEX state), no action
is required.
- If the primary and secondary devices are in SIMPLEX state, reissue
the CESTPAIR command with MODE(COPY) or MODE(NOCOPY).
- If the device specification of the specified primary and secondary
devices does not match that of the primary and secondary device of
an established PPRC volume pair in SUSPEND state, reissue the CESTPAIR
command with the correct device specification and with MODE(RESYNC).
Source
Peer-to-peer remote copy (PPRC).