Explanation
This message provides information for the output
of the XQUERY command for a
"set" report. This message reports
the following values:
- sc_buffers –
- Specifies the maximum number of virtual buffers that the data
mover can allocate per primary storage control in the session. Based
on system activity, the data mover can use fewer buffers. Each virtual
buffer requires 60K of virtual storage.
- page_fix –
- Specifies the number of megabytes of permanently page-fixed storage
that the data mover can use. The more storage that is page-fixed,
the less processor cycles are used by the data mover. Any storage
used above this limit is page-fixed and page-freed as required.
- pace –
- Specifies the number of tracks read or written as part of synchronization
or resynchronization. It is used to pace the data mover impact on
the storage control and primary volume resources.
- copy_type –
- Specifies the type of volume initialization that is performed
for volume pairs for which no copy type was specified on the XADDPAIR
command. The possible values are:
- FULL
- Indicates that the complete volume is copied during volume initialization.
- QUICK
- Indicates that only allocated space at the time the copy starts
is copied during volume initialization.
System action
XRC functions are active.
System programmer response
If the command has been accepted and
this message has not been displayed at either the system console log
or at the user ID specified by the MSGROUTEID parameter, see message
ANTT0099I.
Source
Extended remote copy (XRC).