Explanation
This message provides information for the output
of the XQUERY command for a
"set" report. This message reports
the following values:
- hlq –
- Reports either the high-level-qualifier(hlq)
that was issued on the XSTART command or the default HLQ if none was
specified. The HLQ is used by the data mover to allocate the journal,
state, and control data sets.
- sctrap –
- Specifies whether or not a storage control LIC dump should be
forced by the software if an LIC-related error occurs. YES generates
an LIC dump (if required) on error. NO does not generate an LIC dump
on error. This function is only valid for storage controls that
support the option to dump the LIC.
- timeout_value –
- Reports the timeout interval presently being used for storage
controls. The value is assigned to storage controls as they are added
to the XRC session. It is specified in hours, minutes, and seconds.
It can be reported as STORAGE_CONTROL_DEFAULT if this is the assigned
default.
System action
XRC functions are active.
System programmer response
If the command has been accepted and
this message has not been displayed at either the system console log
or at the user ID specified by the MSGROUTEID parameter, see message
ANTT0099I.
Source
Extended remote copy (XRC).