ANTX5106E
XRC SESSION(session_id) DETECTED A error_type ERROR, REAS=reason_code

Explanation

The XRC software for session session_id has detected an environmental error. The error_type field specifies the likely cause. The reason that is indicated by reason_code provides the reason for the error.

For some of the errors (as indicated below), diagnostic information for the error is placed in SYS1.LOGREC. If a X'9C4' abend is produced with this message, the reason code reason_code is the same as reported in Register 15 for a X'9C4' abend code.

error_type can be one of the following:
  • SOFTWARE – If the XRCTRAP function is set to ON, XRC generates a dump to the SYS1.DUMP data set to capture relevant debugging information. For these errors the system log contains relevant diagnostics.
  • LIC – The storage control can have generated a diagnostic state save. If a state save was not generated, you should ensure that the SCTRAP function is active. This is done by issuing the system console command MODIFY ANTAS000,SCTRAP ON. For these errors, the system log contains relevant diagnostics.
  • HARDWARE – Relevant diagnostics are provided in the system log and in SYS1.LOGREC.
  • STATE_DATASET – An error occurs when XRC is writing to the state data set. Relevant diagnostics, with associated IEC or IOS error messages, are provided in SYS1.LOGREC and in the system log.
  • CONTROL_DATASET – An error occurs when XRC is writing to the control data set. Relevant diagnostics, with associated IEC or IOS error messages, are provided in SYS1.LOGREC and in the system log.

System action

XRC functions are active.

System programmer response

See SDM and XRC return codes for an explanation of the reason codes. Correct the error. Provide all information generated for the particular error type, the system log, and SVC dump of the ANTASnnn address space. If an XRC error is indicated in the system log, search problem reporting databases for a fix for the problem. If no fix exists, provide pertinent SYS1.LOGREC information to the IBM® Support Center.

Based on the return and reason codes, the XRC session or a set of volumes behind one or more storage controls can have been suspended. Correct the problem which caused the failure. You can add the volumes back into the session. If this fails, you might need to suspend the XRC session, restart the session, and after a successful restart, add the volumes back into the session.

Source

Extended remote copy (XRC).

Parent topic: ANT messages