You can do the following in response to either attention message:
- Resume processing by entering a null line after the attention
interrupt. If you are using session manager support at your terminal,
press the ERASE EOF key and then press Enter to enter a null line.
- Enter the TSO/E TIME command. The command runs without ending
the interrupted processing and the attention interrupt remains in
effect.
- Enter the TSO/E ABEND command. The IPCS session abnormally ends
with an IPCS user code of X'072' (decimal 114). The abend
produces a dump if you have a SYSABEND, SYSUDUMP, or SYSMDUMP data
set allocated to your session.
- Enter the TSO/E END command. IPCS ends the interrupted processing.
- Perform other processing by entering any other TSO/E command or
an IPCS subcommand or CLIST. This causes IPCS to end the interrupted
processing and run the new command, subcommand, or CLIST.
If you interrupt and end a subcommand that modifies the problem
directory or the data set directory, the modification to the directory
might be incomplete.
The ATTN statement of CLIST processing is not supported under IPCS.
The scheduling of the attention interrupt causes the IPCS attention
exit to be bypassed and control reverts to the terminal monitor program
(TMP) level.