CEMT SET FECONNECTION

Change the state of FEPI connections. Family selection can be used for TARGET and NODE, but list selection cannot be used.

Syntax

Press the Clear key to clear the screen. You can start this transaction in two ways:

Type CEMT SET FECONNECTION (or suitable abbreviations for the keywords), followed by either TARGET( targetname ) NODE( nodename ) or ALL . The resulting display lists the current status, similar to that obtained by using the CEMT INQUIRE FECONNECTION command. You can tab to the highlighted fields and overtype them with new values.
Type CEMT SET FECONNECTION (or suitable abbreviations for the keywords), followed by either TARGET( targetname ) NODE( nodename ) or ALL , then followed by one or more attribute settings that you want to change. For example, cemt s fec al ac causes sessions to be bound for all FEPI connections.

Typing ? at the beginning of either the first or second line gives a syntax prompt. Resetting the values takes effect immediately.

ACquired: Specifies that the connection is to have a session established (that is, bound). The state is ACQUIRING until this action completes.
ALl: Specifies that any change you request is made to all connections that you are authorized to access.
INSErvice: Specifies that the connection is to be put in service and can be used in a conversation.
NODe(nodename): Specifies the 8-character name of the node that identifies a connection.
Outservice: Specifies that the connection is to be put out of service and not to be used for any new conversations, although existing conversations are unaffected. The service state is GOINGOUT until the existing conversations end.
Released: Specifies that the connection is to have its session ended (that is, unbound), when usage of the connection by all owned conversations ends. An unowned conversation on the connection is ended immediately. The state is RELEASING until this action completes.
Target(targetname): Specifies the 8-character name of the target that identifies a connection.