If you need to apply maintenance to an active
management server,
you can reinstall Copy Services
Manager on
the server without affecting the session.
About this task
Follow these steps to reinstall Copy Services
Manager on the active
management server.
Procedure
- If the heartbeat is enabled, disable it:
- In the menu bar, click .
- On the Advanced Tools page, click Disable
Heartbeat.
- On the standby server, Server 2, issue a take-over. This
makes Server 2 the active server. It is possible that the original
active server, Server 1, is still listed on the Server 2 Management
Servers page. If so, select Remove Standby.
- Disable the heartbeat on Server 2, in case there are any
problems.
- Upgrade Copy Services
Manager on Server
1.
Note: If no changes have been made to the
configuration while Server 1 was being upgraded, steps
5 and
6 are
not necessary.
- When Copy Services
Manager is running
on Server 1, log into Server 2 and set Server 1 as the standby server
for Server 2.
This step copies the configuration from
Server 2 to Server 1. This process takes a few minutes.
- When the management
servers status is synchronized, issue a take-over on Server 1.
This makes Server 1 an active server, able to control sessions.
Note: It
is possible that Server 2 is still listed on the Server 1 Management
Servers page. If this is the case, select Remove Standby.
- Disable the heartbeat on Server 1 to make sure this active
server does not have any problems.
Note: If you
do not need to upgrade Copy Services
Manager on Server
2, skip the next step.
- Upgrade Copy Services
Manager on Server
2.
- On Server 2, go to the Management Servers page and select
the Set This Server As Standby option, entering
the information for Server 1. When this step is complete, Server 1
is the active server, and Server 2 is the standby server.
- When you are confident that the active server is running
without any problems, enable the heartbeat again, if needed.