Model 7014-T42, 7014-B42, and 0553 rack

Hardware specifications provide detailed information for your rack, including dimensions, electrical, power, temperature, environment, and service clearances.

Note: Before installing rear door heat exchangers on your 7014-T42 rack, see Planning for the installation of rear door heat exchangers.

Table 1. Dimensions
Dimensions	Properties
Height	2015 mm (79.3 in.)
Capacity	42 usable EIA units
Height with PDP - DC only	Not applicable
Width without side panels	623 mm (24.5 in.)
Width with side panels	644 mm (25.4 in)
Depth with back door only	1042 mm (41.0 in.)
Depth with back door and front door	1098 mm (43.3 in.)
Depth with sculptured style front door	1147 mm (45.2 in.)
Weight Base rack (empty)	261 kg (575 lb)
Weight Full rack	930 kg (2045 lb) See 7014-T00, 7014-T42 and 0553 rack weight distribution and floor loading
Weight Slim doors	15.4 kg (34 lb)
Weight Side covers	16.3 kg (36 lb)

Table 2. Electrical¹
Electrical characteristics	Properties
DC rack voltage (nominal)	-48 V dc
Power source loading maximum in kVa²	See Power cord options for the 7014, 0551, 0553, and 0555 racks for details
Voltage range (V dc)	-40 - -60
AC rack	683 Btu/hr
Power source loading maximum in kVa (per PDB)³	135 W
Voltage range (V ac)	200 - 240
Frequency (Hz)	50 or 60

Table 3. Service clearances¹
Front	Back	Sides
915 mm (36 in.)	915 mm (36 in.)	915 mm (36 in.)

See your server or hardware specifications for specific requirements.

Rack noise levels are a function of the number and type of drawers installed. See your server or hardware specifications for specific requirements³.

Rack airflow requirements are a function of the number and type of drawers installed⁴. Refer to the individual drawer specifications.

Table 4. Notes
Note: Recommended minimum vertical service clearance from floor is 2439 mm (8 ft) When installing a model 9117-570 or 9406-570 in a 7014-T42 rack, there are restrictions to what height the rack installation can begin so that SMP and FSP flex assemblies are accommodated. The installation configurations are as follows: 16-core configurations (16U) start installation between EIA 1 through EIA 21 12-core configurations (12U) start installation between EIA 1 though EIA 25 8-core configurations (8U) start installation between EIA 1 through EIA 29 4-core configurations (4U) start installation between EIA 1 through EIA 37, EIA 37 through 39 (does not use SMP or SMP flex assemblies) Associated I/O platforms can be mounted in the upper locations of the rack. Acoustic doors are available for the IBM® racks. Feature code 6248 is available for the 0551 and 7014-T00 racks. Feature code 6249 is available for the 0553 and 7014-T42 racks. The overall sound reduction is approximately 6 dB. The doors add 381 mm (15 in.) to the depth of the racks. All rack installations require careful site and facilities planning designed to address both the cumulative drawer heat output and provide the airflow volume rates necessary to comply with drawer temperature requirements.

Caster and leveler locations

The following diagram provides the caster and leveler locations for the 7014-T00, 7014-T42, 0551, 0553, and 0555 racks.

Figure 1. Caster and leveler locations

Send feedback | Rate this page

Last updated: Tue, June 17, 2014